Ring Sizing Instructions for Order of the Engineer

Rings are for the 5^th finger (pinky finger) on your working hand. Right pinky if you are right-handed --OR-- Left pinky if you are left-handed. Since these rings have a wider band, we recommend that you order a half-size up from your initial measurement for a more comfortable fit. Sizes 1.5 through 13.5 are available.

How to Measure Your Finger:

Your ring should fit your finger comfortably—snug enough so that it will not fall off, but loose enough to slide over your knuckle with some resistance. You can print this great ring measurement tool to determine your size by following these instructions:

Print (do NOT scale to fit page) and cut out the ring sizer linked above. When printed, the tool should be 3.5-inch long.
Cut a small slit along line A where you will read the ring size.
Place ring sizer comfortably around your pinkie finger of your working hand by slipping the pointed end of the paper through the slit, numbers facing out.
Secure the ring sizer by pulling the pointed end snuggly around your finger. Be sure that it is not too tight or too loose.
Your approximate ring size should be the number that appears where it says “Read Size Here”
Go up a half-size for the most comfortable fit with this wider ring band.

TIPS for Good Sizing:

When the finger is held straight, the ring should slide off.
When the finger is relaxed, the ring should tug against the knuckle when trying to remove it.
Fingers are smaller when cold and larger when hot. Have your measurement made when their hands are at a “normal” temperature.